Graybeard Outdoors (GBO Reloaded)

H&R Talk => H&R Shotguns => Topic started by: GrampaMike on September 18, 2006, 10:57:45 AM

Title: Topper Shotgun Bead Sight Size
Post by: GrampaMike on September 18, 2006, 10:57:45 AM

Hello,
Does anyone know the thread size and length of the Topper Shotgun front bead sight?
Or where I could buy schematics of H&R/NEF Rifles/Shotguns.
Thanks guys, Mike

Title: Re: Topper Shotgun Bead Sight Size
Post by: Cookiemann on September 18, 2006, 11:24:24 AM

GrampaMike,
Check out this link, it should get ya the schematics for free.  Can't remember about the bead-thread size, but I am sure I have seen it around the forum here somewhere.  Good Luck...here's the link:
http://www.e-gunparts.com/model.asp?idDept=101

cookiemann

Title: Re: Topper Shotgun Bead Sight Size
Post by: lotus on September 18, 2006, 12:09:19 PM

i believe they are 3-56.

Its been a while since I have changed mine, but that number sticks in my mind.

Title: Re: Topper Shotgun Bead Sight Size
Post by: Markus on September 18, 2006, 02:12:57 PM

Lotus is correct. At least thats the listed size for current production.

Title: Re: Topper Shotgun Bead Sight Size
Post by: tfranklin7 on September 19, 2006, 02:21:42 AM

Its a 3-48, The only replacement I could find was -part #446-001-348     3-48 Raybar Shotgun Sight     www.brownells.com
Hope this helps.   Tony



6-48 TPI   Remington/Ithaca/SKB

5-40 TPI    Mossberg

3-56 TPI   Browning Target Citori, Beretta, Kreigoff, Ruger, Weatherby, Winchester, Marlin, Stevens 311, H&R

M3.0-.5    Browning Gold, Citori Field, Franchi, H&K, Fabarm

M3-.6   Browning Citori Hunter

5-44 TPI  Browning BPS

M2.5-.45   S&W

3-48 TPI  New England Firearms

M2-6 will interchange with a 3-56 TPI

Title: Re: Topper Shotgun Bead Sight Size
Post by: GrampaMike on September 19, 2006, 08:30:05 AM

Thanks guys,

I knew there would people here with the answer.
I think between everyone here, we know everything. ;D

Tony went the extra mile with all of his info, hard for me to type that much.

Printed off the whole Thread, will start looking again for my replacement.

Thanks again, Mike