« previous next »
Pages: [1]   Go Down

Author Topic: First trigger job!  (Read 478 times)

0 Members and 1 Guest are viewing this topic.

Offline huntnut

  • Trade Count: (4)
  • Contributor
  • ***
  • Posts: 283
First trigger job!
« on: October 23, 2006, 02:00:54 PM »
 ;D Well just got done doing my first trigger job on my nef, its really easy after you under stand how it goes back to gether, the hardest part was getting those %$**&^*( pins out. Now I have a nice lite & clean trigger pull its around 2#'s I'm guessing its nothing like my accutrigger that was on my savage 22-250 but its alot betterthen it was.
Logged
AIM SMALL MISS SMALL 1 SHOT 1 KILL

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: First trigger job!
« Reply #1 on: October 23, 2006, 02:06:01 PM »
Glad to hear ya did good!! There have been a couple members that had some problems, but if both trigger instructions are read, they pretty much make it easy, it's just a little scary the first time, the next one will be much easier!! ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline PartsMan

  • GBO Supporter
  • Trade Count: (7)
  • Senior Member
  • *****
  • Posts: 1351
  • Gender: Male
  • Proud Handi Owner
    • myspace
Re: First trigger job!
« Reply #2 on: October 24, 2006, 06:19:07 AM »
Diddo
I did a trigger job on mine.
A little scary taking apart but as it turns out
these guns are simple on the inside to!
Logged
Pages: [1]   Go Up
« previous next »