« previous next »
Pages: [1]   Go Down

Author Topic: Timberwolf 357  (Read 424 times)

0 Members and 1 Guest are viewing this topic.

Offline Stan The RT Man

  • Trade Count: (1)
  • Member
  • *
  • Posts: 53
Timberwolf 357
« on: October 28, 2006, 02:24:35 PM »
 Hi,
Has anyone out there removed the trigger and bolt mechanism on a timberwolf pump?
I went to the range with mine after I put a red dot scope on it. I had 3 missfires with no dimple on the primer. I was wondering how to take it apart and clean the bolt?
Thanks
Alki48 (Stan)
Logged

Offline Steve E

  • Trade Count: (4)
  • Contributor
  • ***
  • Posts: 413
  • Gender: Male
Re: Timberwolf 357
« Reply #1 on: November 05, 2006, 05:45:32 AM »
No experience with the Timberwolf but my first thing to look for would be to see if the scope base screws(if it uses them) were sticking down too far into the action and causing problems(too long ?) with the bolt or firing pin. Just a thought. Hope this helps.

                                            Steve E.......
Logged
NRA Endowment Life Member
GOA Life Member
North American Hunting Club Life Member
Pages: [1]   Go Up
« previous next »