« previous next »
Pages: [1]   Go Down

Author Topic: Trigger Alternative  (Read 954 times)

0 Members and 1 Guest are viewing this topic.

Offline acloco

  • Trade Count: (8)
  • Avid Poster
  • **
  • Posts: 202
Trigger Alternative
« on: January 18, 2007, 04:08:49 PM »
http://www.ezpulltriggerassist.com/

I bought one to use on rifles on the bench when testing loads.  Want to take as much of me out of the picture as I can.

I have not yet use the trigger at the range yet - it has been too cold OR too cold AND windy.

Mounted on a Savage 12FV with a consistent 2 lb trigger pull.  Now the measured trigger pull is 0.75 lb.  Installation is easy, but you will need small fingers for two of the screws or a magnetic screwdriver.

Thought I would pass the info along.

One of the nice things - only $40 and can be removed.
Logged

Offline C. Davis

  • Trade Count: (0)
  • Member
  • *
  • Posts: 16
Re: Trigger Alternative
« Reply #1 on: January 18, 2007, 07:37:10 PM »
That looks like a really cool item, but the standard size is for trigger guards with a width of .595 or less. The bigger size is for trigger guards of .595 to .630 of an inch. I just measured the trigger guard of my Handi, and my caliper says it is .632 of an inch wide. Since the handi trigger guards are plastic, I'm sure I could sand it down, but I am not sure I want to do that. I'm glad I measured mine before I ordered. I do have several other guns it would work with though.

C. Davis
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Trigger Alternative
« Reply #2 on: January 18, 2007, 08:35:34 PM »
If it doesn't have enough travel to give a full pull on the trigger, it won't work with the transfer bar very well and would cause inconsistent pin strikes. As easy as trigger jobs are, I'd put the $40 towards a good scope instead of gimicks! ;)

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline ken2222

  • Trade Count: (23)
  • A Real Regular
  • ****
  • Posts: 666
  • Gender: Male
Re: Trigger Alternative
« Reply #3 on: January 18, 2007, 09:05:35 PM »
touchette Tim.......
Logged

Offline acloco

  • Trade Count: (8)
  • Avid Poster
  • **
  • Posts: 202
Re: Trigger Alternative
« Reply #4 on: January 19, 2007, 09:46:24 AM »
Quote from: quickdtoo on January 18, 2007, 08:35:34 PM
If it doesn't have enough travel to give a full pull on the trigger, it won't work with the transfer bar very well and would cause inconsistent pin strikes. As easy as trigger jobs are, I'd put the $40 towards a good scope instead of gimicks! ;)

Tim

Not much of choice but to give a full pull of the trigger.  The roller touches the bottom of your current trigger.  This acts as a mechanical advantage....very simple, but effective.
Logged
Pages: [1]   Go Up
« previous next »