« previous next »
Pages: [1]   Go Down

Author Topic: Ruger Blackhawk Hammer Plunger specs  (Read 407 times)

0 Members and 1 Guest are viewing this topic.

Offline Flash

  • Trade Count: (82)
  • Senior Member
  • *****
  • Posts: 2285
  • Gender: Male
Ruger Blackhawk Hammer Plunger specs
« on: August 06, 2007, 01:37:06 PM »
I am in need of a plunger but the Ruger factory is down for vacation shut-down. Isn't there a way one can be made from 3/32 drill rod and if so, what are the specs for the length and relieved area for the cross pin?
Logged
What doesn't kill us, makes us stronger!

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Ruger Blackhawk Hammer Plunger specs
« Reply #1 on: August 07, 2007, 10:09:15 AM »
Check Brownells, they stock Ruger parts.. As do some of the other suppliers.
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Flash

  • Trade Count: (82)
  • Senior Member
  • *****
  • Posts: 2285
  • Gender: Male
Re: Ruger Blackhawk Hammer Plunger specs
« Reply #2 on: August 07, 2007, 10:52:42 AM »
Got the specs for one off the Ruger forum. Gonna make one from a 3/32 drill bit. Thanks.
Logged
What doesn't kill us, makes us stronger!
Pages: [1]   Go Up
« previous next »