« previous next »
Pages: [1]   Go Down

Author Topic: Proper deminsions for 25-06 case.  (Read 308 times)

0 Members and 1 Guest are viewing this topic.

Offline Dusty Miller

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2271
  • Gender: Male
Proper deminsions for 25-06 case.
« on: October 01, 2007, 10:14:18 AM »
My unfired 25-06 brass is measuring .463" diameter about 3/8" from the bottom of the case.  Some of my fired brass has a little ridge circling the case at that point and the diameter is .470".  Is this a dangerous situation and if not how big can that ridge get before I should discard the case?
Logged
When seconds mean life or death, the police are only minutes away!

Offline jasonprox700

  • Trade Count: (3)
  • Contributor
  • ***
  • Posts: 461
  • Gender: Male
Re: Proper deminsions for 25-06 case.
« Reply #1 on: October 01, 2007, 11:59:56 AM »
Sounds like you might be running some high pressures.  My .280 used to do that until I backed off about a grain.  I never had any seperate, but I they were hard to eject onces in a while.  I would try to back it down a little and see what happens.
Logged
Pages: [1]   Go Up
« previous next »