Author Topic: any one load 35x444 for the g-2  (Read 241 times)

0 Members and 1 Guest are viewing this topic.

Offline tclover

  • Trade Count: (3)
  • Member
  • *
  • Posts: 48
any one load 35x444 for the g-2
« on: October 27, 2007, 05:20:33 PM »
need info and data on this round
This member is currently being investigated for unfair trade practices at GBO and is no longer allowed to use the Classifieds until the matter is cleared up. Posted by Graybeard 01-24-08

Offline Minnesota1

  • GBO Supporter
  • Trade Count: (23)
  • Contributor
  • *****
  • Posts: 379
  • Gender: Male
Re: any one load 35x444 for the g-2
« Reply #1 on: October 27, 2007, 05:51:56 PM »
I have a 358 JDJ which I think is the same thing only yours is made by Coyote guns.  This load that I use is for the 358 JDJ and should be reduced when trying it in your gun or confirmed by either the powder manufacturer or the manufacturer of your barrel.

I shoot a 225 grain Nosler Partition with 51.5 grains of AA2520.  My velocity is about 2290 fps on a 50 degree mostly sunny day in Northern Minnesota.  This is done in an older contender with a 14" hunter barrel.  My group was 9/16" of an inch and just today I shot a 3 shot group of .65"!!  It is a great and accurate load.  SSK say's you can go up to 53 grains with their barrels or their rechambered barrels only.  I did not need to go so high to get the same velocity.  My OAL was 3.237". 

Again this was with a 358 JDJ and should be looked upon like that.  Good luck.

Bob

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26944
  • Gender: Male
Re: any one load 35x444 for the g-2
« Reply #2 on: October 27, 2007, 06:42:13 PM »
DO NOT ASSUME .358 JDJ load data is OK for any other .35-444 version. That kinda assuming can get you hurt.


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!