« previous next »
Pages: [1]   Go Down

Author Topic: Handi 243 transformer!!!!  (Read 785 times)

0 Members and 1 Guest are viewing this topic.

Offline handi243

  • GBO Supporter
  • Trade Count: (53)
  • Senior Member
  • *****
  • Posts: 1119
Handi 243 transformer!!!!
« on: December 09, 2007, 02:06:21 PM »
Went hunting the other day with the 243 ejector can home it was an extractor can't figure it out everything works it just will not eject it pushes the case out like a extractor?
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Handi 243 transformer!!!!
« Reply #1 on: December 09, 2007, 02:23:16 PM »
Spring broke, gummed up, rusted or something like that. Remove and clean it, tune it up per the FAQs.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline PartsMan

  • GBO Supporter
  • Trade Count: (7)
  • Senior Member
  • *****
  • Posts: 1351
  • Gender: Male
  • Proud Handi Owner
    • myspace
Re: Handi 243 transformer!!!!
« Reply #2 on: December 10, 2007, 04:05:23 AM »
If you could get it to do that on command you'd have something. :)

I would clean it real good first.
If that doesn't work take her apart.
Logged

Offline cipher

  • GBO Supporter
  • Trade Count: (1)
  • Member
  • *****
  • Posts: 19
Re: Handi 243 transformer!!!!
« Reply #3 on: December 10, 2007, 02:25:20 PM »
I say hit it with a hammer then clean it.  (Not a big hammer.) :D
Logged

Offline handi243

  • GBO Supporter
  • Trade Count: (53)
  • Senior Member
  • *****
  • Posts: 1119
Re: Handi 243 transformer!!!!
« Reply #4 on: December 10, 2007, 03:24:19 PM »
I have cleaned it very well still can't get it right the only reason i like it is target shooting (i reload) but hunting i like the ejector. I may rebuild it after season goes out.
Logged

Offline PartsMan

  • GBO Supporter
  • Trade Count: (7)
  • Senior Member
  • *****
  • Posts: 1351
  • Gender: Male
  • Proud Handi Owner
    • myspace
Re: Handi 243 transformer!!!!
« Reply #5 on: December 11, 2007, 03:14:15 AM »
http://www.brimstonepistoleros.com/Articles/hr-ejector-mod.html
You might want to look at the old instructions on converting an ejector to extractor.
The "shaded area" should be checked out.
Logged
Pages: [1]   Go Up
« previous next »