« previous next »
Pages: [1]   Go Down

Author Topic: Scope Ring Height  (Read 429 times)

0 Members and 1 Guest are viewing this topic.

Offline scsims

  • Trade Count: (0)
  • Member
  • *
  • Posts: 17
Scope Ring Height
« on: February 28, 2008, 03:11:21 PM »
I am about to purchase a set of Warne steel ring for my prohunter 300 Win Mag, that I'm going to top off with a Bushnell elite 3200 10x40 scope.

What ring height should I use to get enough clearance to pull back the hammer?

Thanks,
Scott
Logged

Offline Grumulkin

  • Trade Count: (33)
  • Senior Member
  • *****
  • Posts: 2028
    • http://www.orchardphoto.com
Re: Scope Ring Height
« Reply #1 on: February 28, 2008, 03:20:19 PM »
If the rings are high enough for the objective diameter, you'll be able to pull the hammer back.

I suspect you'll need medium rings.  On the MidwayUSA web site, there is a link to suggested ring heights when you pull up information on a set of rings.  It will tell you how high the rings should be for a given objective size.
Logged

Offline Bill In SC

  • Trade Count: (2)
  • Avid Poster
  • **
  • Posts: 102
Re: Scope Ring Height
« Reply #2 on: February 28, 2008, 04:26:25 PM »
I'm using Burris Signature Z rings medium height with the 3200 scope on a HB 25-06...   No problems at all getting to the hammer or on the front side with the Obj Bell.

Bill
Logged
Pages: [1]   Go Up
« previous next »