Author Topic: early weatherby vanguard 7mm rem mag  (Read 1278 times)

0 Members and 1 Guest are viewing this topic.

Offline Kotimaki

  • Trade Count: (0)
  • Member
  • *
  • Posts: 16
early weatherby vanguard 7mm rem mag
« on: May 09, 2008, 01:28:58 PM »
I have an old (early 80s ) vanguard that has somehow been neglected for a while. I always liked the way it shot , but hated the trigger. I decided to rework the old girl with a new timney. With a new trigger and some factory ammo results were dismal. So I gave her and a dose of accraglass , outfitted her with some new rings , bases and a VX3. Then made up a few loads of 140 grain nosler ballistic tips with charges of 63 , 64 , 65 , 66 , and 67 grains reloader 19 loaded 10 thou off the lands and off to the range I went. What a dissapointment , 67 grains was the best load at around two inches at 100. Now I have a target taped up in my gun cabinet from 1989 shot with hornady 139 custom that measures .465 So now i dig up some old ammo (139 hornady custom) and go back to the range can you guess where this is going?
yeppers......3 inches. anyone have any ideas for me? I think I have only run 3-400 rounds through this gun , could my throat be eroded that bad? Any advice would be appreciated.....Karl

Offline safetysheriff

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1439
Re: early weatherby vanguard 7mm rem mag
« Reply #1 on: May 09, 2008, 01:47:06 PM »
i'd make very sure that all metal and powder fouling are out of the bore.   when you look at the muzzle you need to see that the rifling is not filled in/rounded out.   it can be somewhat difficult to tell on some rifles; but the metal and powder will fill in the rifling and you have to look at the muzzle from different angles to verify that it is not clogged with 'crap'.

i clean mine 'til the rifling is visible with a 4x magnifying glass.   i use various cleaners and LOTS of bronze bore brushing to get the barrel clean.    make sure the firing pin can properly be 'pushed' through its opening in the bolt.   

make sure the muzzle crown is not damaged.    make sure nothing is loose.   base(s), rings, stock screws, etc.   spray the trigger group generously with the stock removed from the rifle to clean and lubricate the trigger and related parts.   

since that 1989 target was shot, you have aged by 19 years.   or nearly so.   are you more sensitive to recoil now?   hold that rifle tightlly, like a brand new bride, and it'll help absorb recoil.   a loosely held rifle lets the recoil give the gun ''a run'' at you.   it's hard on the scope, rings, base(s), and your shoulder.

lastly,  don't give up.   it'll probably shoot if you persist.

take care,

ss'   
Yet a little while and the wicked man shall be no more.   Though you mark his place he will not be there.   Ps. 37.