Author Topic: 360DW case length gage  (Read 322 times)

0 Members and 1 Guest are viewing this topic.

Offline yukondog

  • GBO Supporter
  • Trade Count: (43)
  • Senior Member
  • *****
  • Posts: 1095
360DW case length gage
« on: July 06, 2008, 11:13:58 AM »
Anybody have any idea where I could get case length gage for the 360DW and the 357max.?
an unloaded wepon is equal to the same mass and volume as a rock.

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 360DW case length gage
« Reply #1 on: July 06, 2008, 02:17:07 PM »
Lee will make you one for $19, but I'd just cut down or shim an existing gage. A few small washers on the threaded stud of a 357mag gage would work for the 360DW and a 35 Remington gage may work if cut down for the Maxi.
 
Tim

http://leeprecision.com/cgi/catalog/browse.cgi?1215389366.4950=/html/catalog/custom.html#CUSTOMCASELENGTHGAUGE
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline vinpar092

  • Trade Count: (0)
  • Member
  • *
  • Posts: 69
  • Gender: Male
Re: 360DW case length gage
« Reply #2 on: July 07, 2008, 06:25:03 PM »
I ordered a DW at 1.39" from LEE last week and they said it would be 6-8 weeks before it would ship. That Project is on hold till then. I tried to shim it Tim but couldn't get exactly what I wanted so I just ordered one.

Vince

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 360DW case length gage
« Reply #3 on: July 07, 2008, 06:49:17 PM »
Use washers to get it close but a little long, then trim the skinny end with a dremel until it trims to the correct length.  ;)

Tim
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline vinpar092

  • Trade Count: (0)
  • Member
  • *
  • Posts: 69
  • Gender: Male
Re: 360DW case length gage
« Reply #4 on: July 08, 2008, 03:34:09 PM »
Didn't think about trimming it like that. Great Idea. I may have to trim a little more anyway to fit like I want. I can stretch the bullet out but the chamber wants a smaller case. Thanks as usual Tim.

Vince