sight question

[sachel.45]

would the williams wgrs guide sight thats made for the handi rifle match the contour on the 12 gauge shotgun? (specficaly for the sb1-f12 camo turkey) or is there a diffrent reciever sight that would fit better? i plan on using that epoxy or the black loctite also how do you figure the contour on the front of the barrel (for the front sight)

[quickdtoo]

Yes, all of the H&R break barrels have 1.1XX" chamber swells except the 10ga/12ga USH so the WGRS will fit fit fine. If you use the Black Max, I'd lap the sight base so it matches the barrel closely. The Williams shotgun shorty ramps are made for 12ga barrels, they're for .815" and .875" diameter barrels, and available in 4 different heights.

Tim

http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=156471&t=11082005

http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=687196&t=11082005

[STUMPJMPR]

This is what i used on a 12ga my front sight was a little too short i believe


285564   Williams Fire Sight Rifle Bead .450" Height, .250" Width Steel Blue 3/32" Fiber Optic Red   
330260   Loctite 380 Instant Adhesive Black Max 3 gm   
496762   Williams WGRS-Guide Receiver Peep Sight "Ghost Ring" Aperture Aluminum Black   
687196   Williams Shotgun Shorty Ramp 12 Gauge 1/8" (.875) Blue   
698217   Williams WGRS-H&R Guide Receiver Peep Sight H&R 158, 258 Topper Single Shot Rifles, Ruger Mark 2 Aluminum Black