Author Topic: deer hunting roundball 62cal. fusil loads?  (Read 452 times)

0 Members and 1 Guest are viewing this topic.

Offline hans g./UpS

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 273
deer hunting roundball 62cal. fusil loads?
« on: August 01, 2003, 08:08:24 AM »
Anyone using a 62cal. fusil with roundball for deer?
What load do you use?
Thanks.

Offline Anduril

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 335
deer hunting roundball 62cal. fusil loads?
« Reply #1 on: August 04, 2003, 12:35:21 PM »
hans g
i also saw your post on another site
check this out for some good info

http://members.aye.net/~bspen/SmoothboreLoads.html

Offline olduvai george

  • Trade Count: (0)
  • Member
  • *
  • Posts: 42
deer hunting roundball 62cal. fusil loads?
« Reply #2 on: August 04, 2003, 01:20:32 PM »
hans g.   i've had one successful hunt on a mid-weight virginia whitetail buck using a .602 soft ball,  greased pillow tick  .017 patch, and 70 gr. 2f goex in a 20 ga. 36"  barrel flint smooth rifle.  the deer was slightly at an angle coming to me at about 35 yards.  at the hammer drop it angled a little more and ducked down in front.  the ball angled from just under the spine near the last rib through the opposite side hip joint and ended up just under the skin looking like a 1/4" thick quarter.  the deer left a poor blood trail for 80 yards before expiring.  because it had ducked, and since there was no exit of the ball ,  virtually all bleed out was internal.  i had  attempted to aim at the base of the throat where the hair on a whitetail changes direction of lay.  i don't prime with 2f any more.   crushed 2f is much faster.  good fortune to your hunts, regards, olduvai george