« previous next »
Pages: [1]   Go Down

Author Topic: 6tcu fireforming loads  (Read 925 times)

0 Members and 2 Guests are viewing this topic.

Offline KYODE

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1050
  • Gender: Male
6tcu fireforming loads
« on: December 16, 2002, 02:19:41 AM »
what is recommended for fireforming loads? would it be ok to start 2 grains below maximum 6tcu data? is it recommended to try different bullets and powder for accuracy with these loads, or just anything to make it go boom to form the case? does anyone hunt with the forming loads? anything anyone can recommend is welcome. thanks, KYODE
Logged

Offline IronMonkey

  • Trade Count: (0)
  • Member
  • *
  • Posts: 96
fireforming
« Reply #1 on: December 16, 2002, 03:12:01 AM »
Most guys shoot whatever they have lying around.  If you load the bullets correctly even the fireforming loads can be accurate.   The important thing is to go with 90% of max charge to get the brass properly formed.  Then to make sure that you don't set the shoulder back when you load the new brass.  Other than that, I shoot silhouette with my fireform loads and the only thing missing the steel is me!  Dan
Logged
Gun control is shooting 40x40!

Offline KYODE

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1050
  • Gender: Male
6tcu fireforming loads
« Reply #2 on: December 16, 2002, 08:00:55 AM »
just noticed i have a very long throat. it is a factory 6tcu. there is only about 1/8" of neck holding a rem bulk 80gr PLHP. reckon that'll be ok?
Logged
Pages: [1]   Go Up
« previous next »