« previous next »
Pages: [1]   Go Down

Author Topic: 700 ADL trigger p  (Read 476 times)

0 Members and 2 Guests are viewing this topic.

Offline redhawksixsh

  • Trade Count: (0)
  • Member
  • *
  • Posts: 72
700 ADL trigger p
« on: January 26, 2009, 02:37:21 PM »
Hey guys.  I have a 700 ADL wood in 30.06.  The trigger pull is about 6 lbs.  I have no problem getting the trigger down to 3.5 lbs.  However, if I lower the trigger pull, creep shows up.  When the pull is 6 lbs., no creep. At 3.5 lbs., excessive creep, even after adjusting sear engagement and overtravel screws. Help!
Logged

Offline charles p

  • GBO Supporter
  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 2374
  • Gender: Male
Re: 700 ADL trigger p
« Reply #1 on: January 26, 2009, 03:31:29 PM »
Are you following the directions in the stickey above and elsewhere of the furum.  I can get all mine so low that it is scarry.  About 3lb is good for my hunting.  I have the old triggers.
Logged

Offline redhawksixsh

  • Trade Count: (0)
  • Member
  • *
  • Posts: 72
Re: 700 ADL trigger p
« Reply #2 on: January 27, 2009, 01:41:06 PM »
I figured it out.  I just needed to start over and slow the process down.  I now have a very nice trigger pull,  one of the best triggers of all my rifles.  I did go through a complete safety check and all seems well.  I will let ya'll know how it shoots when it warms up.  Thanks all.
Logged
Pages: [1]   Go Up
« previous next »