« previous next »
Pages: [1]   Go Down

Author Topic: recrowning a chrome lined barrel  (Read 521 times)

0 Members and 1 Guest are viewing this topic.

Offline olduvai george

  • Trade Count: (0)
  • Member
  • *
  • Posts: 42
recrowning a chrome lined barrel
« on: August 29, 2003, 11:38:32 AM »
Sirs:  can a chrome lined (ar-15 to be exact) barrel be re-crowned?  how does one deal with the extra hard chrome in terms of lathe technique or tooling?  thanks for any assistance you may offer.  olduvai george
Logged

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
recrowning a chrome lined barrel
« Reply #1 on: August 29, 2003, 12:12:55 PM »
Shouldn't be a problem. I would be sure and make the finnish pass on the crown from the inside out. Less chance of "chipping or flaking" the chrome edge.   KN
Logged

Offline John Traveler

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1359
re-crowning a barrel with chrome-plated bore
« Reply #2 on: August 29, 2003, 01:02:44 PM »
Use standard lathe technique to cut crown with VERY light cuts and slowest feed to minimize chance of flaking the chromium from the bore.

Use finest abrasive past on a Teflon block for finish.

John
Logged
John Traveler
Pages: [1]   Go Up
« previous next »