« previous next »
Pages: [1]   Go Down

Author Topic: Lyman/RCBS top punch for Rapine .358 RNFP?  (Read 390 times)

0 Members and 1 Guest are viewing this topic.

Offline Dakota Confederate

  • Trade Count: (0)
  • Member
  • *
  • Posts: 21
Lyman/RCBS top punch for Rapine .358 RNFP?
« on: August 29, 2003, 01:04:26 PM »
Just got in my Rapine 158 grain RNFP-HB mould from Buffalo arms today. I plan to run them through my Lyman 450 Lubrisizer but I'm not sure what Lyman or RCBS top punch I need for this bullet design. Anybody know off hand what size I need? Thanks.  :-)
Logged

Offline Johm D M

  • Trade Count: (0)
  • Member
  • *
  • Posts: 50
Lyman/RCBS top punch for Rapine .358 RNFP?
« Reply #1 on: August 29, 2003, 01:12:12 PM »
I have run most flat point bullets through a sizer with a 1/4" bolt and the flats ground down to less than diameter if you don't have the right one on hand. If you use a grade 8 bolt you will have the 3 lines visible on the face though. Gianni.
Logged
Pages: [1]   Go Up
« previous next »