« previous next »
Pages: [1]   Go Down

Author Topic: Is the fuse hole of the 0,220" too big?  (Read 396 times)

0 Members and 1 Guest are viewing this topic.

Offline oyvind

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 107
Is the fuse hole of the 0,220" too big?
« on: June 17, 2009, 10:59:28 AM »
Hi. Is the fuse hole of the 0,220" too big?
Fuse that I have is 0,196 "
What do you think.

Mvh
Logged

Offline Double D

  • Trade Count: (3)
  • Senior Member
  • *****
  • Posts: 12609
  • SAMCC cannon by Brooks-USA
    • South African Miniature Cannon Club
Re: Is the fuse hole of the 0,220" too big?
« Reply #1 on: June 17, 2009, 01:10:10 PM »
Sounds like your fuse is 5mm. 6 mm should work
Logged

Offline Artilleryman

  • Moderator
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1378
Re: Is the fuse hole of the 0,220" too big?
« Reply #2 on: June 17, 2009, 02:19:39 PM »
What are the sizes of your vent tools?
Logged
Norm Gibson, 1st SC Vol., ACWSA

Offline Rickk

  • GBO Supporter
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1391
    • http://www.lioby.com
Re: Is the fuse hole of the 0,220" too big?
« Reply #3 on: June 17, 2009, 02:52:55 PM »
what size is the bore?  If the bore is big enough it probably doesn't matter as much.

Personally, I use .125" fuse and prefer .200 holes . Your not too far off.
Logged
Pages: [1]   Go Up
« previous next »