« previous next »
Pages: [1]   Go Down

Author Topic: Parts interchange H&R 48 & modern NEF/H&R  (Read 407 times)

0 Members and 1 Guest are viewing this topic.

Offline GatCat

  • Trade Count: (25)
  • A Real Regular
  • ****
  • Posts: 666
Parts interchange H&R 48 & modern NEF/H&R
« on: August 13, 2010, 09:43:39 PM »
Hi...I was at a gunstore, noticed a 16 ga. H&R Model 48 that has the steel trigger guard and fore-arm spacer. Any idea if these can be used on newer rifles?
Thanks,
Mark
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: Parts interchange H&R 48 & modern NEF/H&R
« Reply #1 on: August 14, 2010, 06:04:51 AM »
More than likely it will be close, but there may be some differences, most likely the fit at the rear of the trigger guard, and the pin spacing may or may not be close, as with all H&R parts, their tolerances leave a bit to be desired.

Tim
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »