« previous next »
Pages: [1]   Go Down

Author Topic: screw size  (Read 475 times)

0 Members and 1 Guest are viewing this topic.

Offline hiram

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 145
screw size
« on: October 09, 2003, 05:32:58 PM »
I have a 1902 rem rolling block that was in 7mm. It will be rebarreled. Does anyone know the thread size of the tang screw? I get 26 tpi, but I can't find that in the tap and die charts. Thanks.  :P
Logged

Offline John Traveler

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1359
Rolling Block tang screw
« Reply #1 on: October 10, 2003, 06:10:54 AM »
It has been a while since I've checked, but that tang screw should be 1/4-28 size.  Even the licensed oreign- manufactured actions used English SAE sized screws.

John
Logged
John Traveler

Offline hiram

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 145
screw size
« Reply #2 on: October 10, 2003, 11:13:51 AM »
Thank you for the info--
Logged

Offline Flint

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1053
thread
« Reply #3 on: October 15, 2003, 06:43:49 AM »
If the thread pitch is really 26, it is probably 1mm, which might make the screw an M6x0.1.  Check that easily enough with a 6mm screw.
Logged
Flint, SASS 976, NRA Life
Pages: [1]   Go Up
« previous next »