Looking for....

[Dirt Bag]

   Any of you folks know where we could get a pair of QD swivels with narrow loops for a 3/4, or even 7/8 inch sling?  Is there such a thing?
                                  Have a good one;
                                                                              D.B.
                       

[gunnut69]

If they are available Brownells will have them.. I didn't look them up but a call to their tech line would likely find out for you..800-741-0015 . These are good people, give them a call.

[Dirt Bag]

Thank you Sir;...... I went through their catalog, and also Numrich's. No go. We have a Model 64 Winchester with the factory swivels on it, and they are narrow enough, but way to bulky for where we want to put them. Have been working over a old Chipmunk rifle for our Grandson - and trying to keep everything scaled down proportionatly. The Dakota bases look good, but a one inch sling would be a little much. A sling we can make (buckles and reins from an old bridle, harness etc.)  Could probably section out and re weld the loops on some one inchers, but only if we have to.
     Appreciate the reply,                            Best;
                                                                          D.B.

[gunnut69]

I've posted a link below to the UncleMikes website. If anybody makes them they will have them. Did you call the Brownells helpline. They are very knowledgeable and may have what you want but just don't have it listed

http://www.uncle-mikes.com/

[Rangr44]

They are properly referred to as "European" type swivel loops - and I have two sets I can make available for you for MUCH less than the new ones that New England Custom Gun makes/sells.

       

They are available from NECG as QD swivels or non-QD

www.newenglandcustomgun.com

.

.