« previous next »
Pages: [1]   Go Down

Author Topic: 40 cal & lube?  (Read 428 times)

0 Members and 1 Guest are viewing this topic.

Offline beerbelly

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 1625
40 cal & lube?
« on: January 17, 2011, 05:26:26 AM »
I just cast some 40 S&W using a lee mould and sizer. I used Lee L A lube. I am wondering if I need to re-lube after sizing? The sizing only removes the lube from the driving bands. It looks to me the case would remove this lube when you seat the bullet. What do you guys think or how do you do ?
                                        Beerbelly
Logged

Offline stimpylu32

  • Moderators
  • Trade Count: (67)
  • Senior Member
  • *****
  • Posts: 6062
  • Gender: Male
Re: 40 cal & lube?
« Reply #1 on: January 17, 2011, 10:11:54 AM »
BB

Lee says to re-lube after sizing , for what its worth , I don't and have not had a problem with leading yet , if the case mouth is properly belled it should not shave the lube from the bullet .

Try a few each way and see what works best , all of mine are shot in wheelguns so an auto-loader may act differently with their bullets .

stimpy 
Logged
Deceased June 17, 2015


:D If i can,t stop it with 6 it can,t be stopped

Offline beerbelly

  • Trade Count: (6)
  • Senior Member
  • *****
  • Posts: 1625
Re: 40 cal & lube?
« Reply #2 on: January 17, 2011, 02:17:46 PM »
stimpy, i think you nailed it. I went ahead and relubed, I doubt you can have to much lube. But I think you are right I need to bell my brass a bit more. I have almost none. Thanks.
Logged
Pages: [1]   Go Up
« previous next »