« previous next »
Pages: [1]   Go Down

Author Topic: reloading problem  (Read 377 times)

0 Members and 1 Guest are viewing this topic.

Offline tony212

  • Trade Count: (3)
  • Contributor
  • ***
  • Posts: 280
reloading problem
« on: October 29, 2003, 12:25:14 PM »
I have reloaded several boxes of .300 win mag without any problems, but the last two boxes had a few rounds that I couldn't chamber fully.  I couldn't get my bolt handle to close on them.  I tried seating the bullets deeper, but that didn't help.  I miced my cases and the ones that worked were 2.617, the ones that didn't were 2.623. I tried trimming the cases a little and they seemed to work. However, I just sized some cases and before I trimmed them I tried them in the chamber.  They worked fine. When I miced them they were 2.633.  Am I missing something here?  I readjusted my sizing die,  I'm not sure if that would cause this problem.  If anyone has any suggestions please let me know.....
Thanks
Tony212 :-)
Logged

Offline KN

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1962
reloading problem
« Reply #1 on: October 29, 2003, 12:41:24 PM »
It could be that the empty cases your putting in the chamber are going because there is no bullet to hold the neck diameter to a precise size. What I mean is that it could be trying to put a little "crimp on the case and you don't realize it. with a bullet installed the case neck can't "crimp at the chamber end and won't allow it to fully insert in the chamber. Just something to consider.  KN
Logged
Pages: [1]   Go Up
« previous next »