Author Topic: High pressure 7.62x25  (Read 430 times)

0 Members and 1 Guest are viewing this topic.

Offline S.S.

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2840
High pressure 7.62x25
« on: August 26, 2004, 02:52:36 PM »
This may have been mentioned before but you can't be too careful
Check out this link....
http://www.geocities.com/Yosemite/Gorge/4653/bad.htm
Vir prudens non contra ventum mingit
"A wise man does not pee against the wind".

Offline 1911crazy

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 4793
  • Gender: Male
High pressure 7.62x25
« Reply #1 on: August 27, 2004, 04:03:00 AM »
Good post there is some bad ammo out there.  I only buy new Sellier & Bellot 7.62x25 ammo.                                              BigBill

Offline Mikey

  • GBO Supporter
  • Moderator
  • Trade Count: (2)
  • Senior Member
  • *****
  • Posts: 8734
High pressure 7.62x25
« Reply #2 on: August 27, 2004, 04:07:36 AM »
S. Sumner:  those pictures say it all and those are some nasty shots.  When we started shooting our Toks some of the chinese ammo we would get (all we could get then) had some serious fluctuations in pressures and lots of us were very happy when Sellier and Bellot came out with their loadings.  

Had some hot Chech stuff lock back a few Tokarev slides at the range one day and the shooters became very uncomfortable and some quite scared of shooting their pistols again.

The article is right about either just trashing the ammo or at least pulling the bullets but I think trashing is best.  Some of those loadings used undersized bullets and the resultant accuracy isn't worth the effort to pull and then reload them.  

BTW, have you had the chance to try some of the reloads talked up on the Curio and Relic site - reloads are being offered and they sound very nice although I wonder is some might not be too hot for the Tok.  Hope all is well.  Mikey.

Offline S.S.

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2840
High pressure 7.62x25
« Reply #3 on: September 02, 2004, 04:45:04 AM »
The CZ52 was actually designed around a round that their Government
designated the M48 ? (I'll repost if that is the wrong Number)
According to the Jane's infantry weapons 1978 edition (in my opinion the
world authority on military equipment) The M48 round was loaded to
about 10% higher pressure than the soviet 7.62x25 Tok round.
These are some extremely robust handguns, and I think that it would
take some terribly high pressure rounds to do the damage shown in those pictures.
Vir prudens non contra ventum mingit
"A wise man does not pee against the wind".