« previous next »
Pages: [1]   Go Down

Author Topic: Lee Mold  (Read 356 times)

0 Members and 1 Guest are viewing this topic.

Offline beng

  • Trade Count: (0)
  • Member
  • *
  • Posts: 35
  • Gender: Male
Lee Mold
« on: October 12, 2010, 10:56:32 AM »
 I have a guick question about the Lee mold, 459-500-3R.   Will it work OK in a 32"  BC  45-70?    Will be using it at 200 and 300 yds.  Target loads, with 4198 or if anything other that could work better than 4198.    ( I have many many pounds of it)    beng
Logged
beng

Offline necchi

  • GBO Supporter
  • Trade Count: (40)
  • Senior Member
  • *****
  • Posts: 1842
  • Gender: Male
Re: Lee Mold
« Reply #1 on: October 12, 2010, 11:20:25 AM »
The bullet IS listed for use in the 45-70 so your good to go there,,but I can't help with load data for the powder you want to try
Logged
found elsewhere

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43300
  • Gender: Male
Re: Lee Mold
« Reply #2 on: October 12, 2010, 11:26:28 AM »
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »