« previous next »
Pages: [1]   Go Down

Author Topic: case neck broke off in sizer die  (Read 469 times)

0 Members and 1 Guest are viewing this topic.

Offline ba_50

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 222
  • Gender: Male
case neck broke off in sizer die
« on: October 20, 2010, 03:05:10 AM »
A .243 neck stayed in the die and was wondering how to get it out. I'll see if I can find a wood dowel that fits and push it out. Thanks for any ideas.
Logged

Offline SHOOTALL

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 23836
Re: case neck broke off in sizer die
« Reply #1 on: October 20, 2010, 03:15:16 AM »
an easy out will work. When I shot IMHSA we had an easy out welded to a length of drill rod with a t handle on the other end to reach into mainly XP-100's to retrive necks and half cases. We would shoot brass way to many times but money was tight .
Logged
If ya can see it ya can hit it !

Offline Glanceblamm

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2814
Re: case neck broke off in sizer die
« Reply #2 on: October 20, 2010, 04:33:30 AM »
Check your outlets (say Menards or Lowes) if you don't own a tap n die set as the easy out's can often be purchased in indiviual packages.
Logged

Offline necchi

  • GBO Supporter
  • Trade Count: (40)
  • Senior Member
  • *****
  • Posts: 1842
  • Gender: Male
Re: case neck broke off in sizer die
« Reply #3 on: October 20, 2010, 04:53:03 AM »
When all else fails, stick it in the freezer.
Logged
found elsewhere

Offline mbopp

  • Trade Count: (5)
  • Avid Poster
  • **
  • Posts: 209
  • Gender: Male
Re: case neck broke off in sizer die
« Reply #4 on: October 20, 2010, 05:13:35 AM »
You may want to email the die manufacturer and see what they say.
If it were me (assuming the decapper stem is out) I'd try running a 14-28 tap in it, then use a 3/16 rod or bolt in the top of the die and hammer the tap (and neck) out. YMMV.
Logged
"The Constitution is not an instrument for government to restrain the people, it is an instrument for the people to restrain the government, lest it come to dominate our lives and interests." -- Patrick Henry, American Patriot

Offline Paladin

  • Trade Count: (6)
  • Contributor
  • ***
  • Posts: 313
Re: case neck broke off in sizer die
« Reply #5 on: October 20, 2010, 04:59:12 PM »
a tapered rat tail file will work in a pinch  ;D
Logged

Offline ba_50

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 222
  • Gender: Male
Re: case neck broke off in sizer die
« Reply #6 on: October 20, 2010, 05:43:46 PM »
I used a small screw driver sharpened to a point to push on the top edge after spraying it with WD40 and it popped out real easy. Big suprise. I'll remember the easy out next time around. Thanks.
Logged
Pages: [1]   Go Up
« previous next »