« previous next »
Pages: [1]   Go Down

Author Topic: Uberti Patterson  (Read 593 times)

0 Members and 1 Guest are viewing this topic.

Offline The Shrink

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 557
Uberti Patterson
« on: December 08, 2003, 01:17:38 AM »
Esteemed Board

I have the Uberti Patterson with the loading lever.  Two questions:

1)  I notice that when cocked quickly the cylinder will over-turn.  I imagine with that small pin instead of a bolt that it is a design flaw, corrected on later models.  Am I correct?

2)  The cutout for loading is not large enough to place a ball on the cylinder under the loading lever.  I'll still have to use the separate Patterson loading tool to load.  What's the point of the lever?
Logged
Wayne the Shrink

There is no 'right' that requires me to work for you or you to work for me!

Offline Full House

  • Trade Count: (0)
  • Member
  • *
  • Posts: 60
Uberti Patterson
« Reply #1 on: December 12, 2003, 11:34:08 AM »
My copy of the periodical "Guns of the Old West" came today (winter 2004) and there is a feature on the Patterson.  A four page article full of good stuff.  Check it out.


Aces and Eights
Logged
Full House

Offline The Shrink

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 557
Uberti Patterson
« Reply #2 on: December 13, 2003, 05:18:16 AM »
I've never seen it.  Can you give me specifics so I can snag a copy?
Logged
Wayne the Shrink

There is no 'right' that requires me to work for you or you to work for me!
Pages: [1]   Go Up
« previous next »