« previous next »
Pages: [1]   Go Down

Author Topic: Help- PACIFIC CASE TRIMMER  (Read 979 times)

0 Members and 2 Guests are viewing this topic.

Offline RWK

  • Trade Count: (2)
  • Contributor
  • ***
  • Posts: 266
Help- PACIFIC CASE TRIMMER
« on: February 09, 2011, 02:10:58 PM »
Have any of you folks ever used a Pacific cartridge trimmer, how do you get the cutter out of the spindle. Rich
Logged

Offline huntducks

  • Trade Count: (4)
  • Contributor
  • ***
  • Posts: 337
  • Gender: Male
Re: Help- PACIFIC CASE TRIMMER
« Reply #1 on: February 12, 2011, 07:48:05 AM »
You most likely don't if it's the same as the old Forester it's 1 piece and you send the whole shaft back to the Co. for sharpening.
Logged
Remember it's where the first bullet goes out of a cold barrel that counts most.

Offline gman628

  • Trade Count: (3)
  • Avid Poster
  • **
  • Posts: 127
Re: Help- PACIFIC CASE TRIMMER
« Reply #2 on: February 12, 2011, 02:13:04 PM »
If it's like mine, it's a one pc. and not removeable.  I bought mine as a going out of business one so I got it cheap enough that when the blade is too dull to cut I'll take it to a machinist buddy of mine to try to sharpen it, if that don't work, I'll pony up for a new Hornady with carbide cutter.  By the way, Hornady bought out Pacific so all the pilots fit your pacific.

Logged

Offline RWK

  • Trade Count: (2)
  • Contributor
  • ***
  • Posts: 266
Re: Help- PACIFIC CASE TRIMMER
« Reply #3 on: February 12, 2011, 04:58:54 PM »
Thanks guys thats what i got. Rich
Logged
Pages: [1]   Go Up
« previous next »