Author Topic: breach plug question  (Read 1011 times)

0 Members and 1 Guest are viewing this topic.

Offline Jason F

  • Trade Count: (261)
  • Senior Member
  • *****
  • Posts: 2105
  • Gender: Male
breach plug question
« on: May 08, 2011, 03:59:07 PM »
when you screw breach plug in is one of the slots in plug supposed to line up with the wide slot in barrel,when mine is screwed in the slots in breach plug are straight up and down,and where can i buy primer carriers,or breach plug that just uses 209 primers without carrier
handi rifles- 22 mag      22 hornet    223      7mm-08      308 chip shot     30-30 x2     30-06 shorty      358 cheez whiz     357 max     35 remington     375-08    410 rifled slug     454 casull     460 s&w     45 smokeless muzzleloader x2     45-70    50 huntsman    50-70 government shikari     20 ga.ush     12 ga.ush    12 ga.3 1/2     10 ga.imp.cyl. slug gun

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: breach plug question
« Reply #1 on: May 08, 2011, 06:47:50 PM »
See the sticky above..  ***attention all please read*** 

Tim
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline TheCrowkiller

  • Trade Count: (0)
  • Member
  • *
  • Posts: 23
Re: breach plug question
« Reply #2 on: May 12, 2011, 06:07:16 AM »
My slot did not line up when it was fully seated. I never worried about it and it worked fine. H&R/NEF should still have some primer carriers for sale.

The only two flaws in my Huntsman are the breech plug and the ramrod. Both of these are a bit Rube Goldberg for my taste. I hope these are addressed by Cerberus.

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: breach plug question
« Reply #3 on: May 12, 2011, 06:41:10 AM »
"Always do right, this will gratify some and astonish the rest" -  Mark Twain