« previous next »
Pages: [1]   Go Down

Author Topic: Krieghoff Insert Barrel Installation  (Read 1647 times)

0 Members and 1 Guest are viewing this topic.

Offline dougk

  • Moderator
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1937
  • Driftwood TEXAS
Krieghoff Insert Barrel Installation
« on: April 25, 2011, 07:21:37 AM »
I finally go to the Krieghoff barrel insert and reading the instructions there is talk of milling.
Has anyone installed the Krieghoff insert?  Is there milling?  Should it be done by a gun smith?

thanks
Doug
Logged

Offline dougk

  • Moderator
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1937
  • Driftwood TEXAS
Re: Krieghoff Insert Barrel Installation
« Reply #1 on: April 26, 2011, 10:21:02 AM »
I talked to my drilling smith and the barrel insert is off to him to install on the Funk drilling he is working on.  The is metal cutting involved to fit the insert...
Logged

Offline Drilling Man

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3634
Re: Krieghoff Insert Barrel Installation
« Reply #2 on: April 26, 2011, 11:34:05 AM »
  Well, you don't "have" to, but having a cut in the extractor guarantees that it will go back in the exact same way each time it's inserted.

  DM
Logged

Offline dougk

  • Moderator
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1937
  • Driftwood TEXAS
Re: Krieghoff Insert Barrel Installation
« Reply #3 on: April 26, 2011, 05:56:34 PM »
JJ was working on the Funk and the barrel insert is not that much more.  Plus he did a great job mounting the insert on the Sauer drilling.
Logged
Pages: [1]   Go Up
« previous next »