« previous next »
Pages: [1]   Go Down

Author Topic: Remignton 870 Shell Latch  (Read 614 times)

0 Members and 1 Guest are viewing this topic.

Offline Bullseye

  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 1879
Remignton 870 Shell Latch
« on: May 01, 2011, 04:53:45 PM »
One of the shell latches came out of the reciever on my 870 tonight.  I got the gun back together by holding it in place with a screwdriver and putting the trigger mechanism in.

These appear to be peened into place.  It there some secret to re-peen them into place or better to just live with it loose.
Logged

Offline gunnut69

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 5005
Re: Remignton 870 Shell Latch
« Reply #1 on: May 01, 2011, 10:05:53 PM »
The peening you see is meant to retain the latch until the fire control mechanism can be installed to actually retain it. I have made an offset punch to restake (note the receiver must be supported when doing this).  Don't usually bother too much. The front fire control retaining pin holds the stop in correct alignment for proper function.
Logged
gunnut69--
The 2nd amendment to the constitution of the United States of America-
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms, shall not be infringed."

Offline Bullseye

  • Trade Count: (9)
  • Senior Member
  • *****
  • Posts: 1879
Re: Remignton 870 Shell Latch
« Reply #2 on: May 03, 2011, 04:03:36 PM »
Thanks gunnut69.

I think I will just leave it alone for the time being.  The side it is on you can still get the fire control mechanism in while holding the shell latch.  That sounds like a better option than trying to re-stake it without the proper tool.
Logged
Pages: [1]   Go Up
« previous next »