« previous next »
Pages: [1]   Go Down

Author Topic: Remington 7600 scope mount and rings???  (Read 1303 times)

0 Members and 1 Guest are viewing this topic.

Offline NYH1

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1695
  • Gender: Male
Remington 7600 scope mount and rings???
« on: August 23, 2011, 07:07:56 PM »
I have a Remington 7600 Carbine on order. I'm going to put an older Redfield 3-9x40mm Scope on it. Can I use Leupolds (or Redfields) standard one piece mount with their low rings with this set up?  I want the scope mounted as low as possible.    Thanks, NYH1!
Logged
"ROLL TIDE". . .Back To Back. . .Three In The Last Four Years "GO GIANTS"  "YANKEES"

Offline Bigeasy

  • Trade Count: (5)
  • Senior Member
  • *****
  • Posts: 1986
  • Gender: Male
Re: Remington 7600 scope mount and rings???
« Reply #1 on: August 24, 2011, 05:05:13 AM »
It should work fine, as long as the scopes objective bell clears the barrel.  If in doubt about the clearance, contact Leupold's customer service and ask.
 
Larry
Logged
Personal opinion is a good thing, and everyone is entitled to one.  The hard part is separating informed opinion from someone who is just blowing hot air....

Offline NYH1

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1695
  • Gender: Male
Re: Remington 7600 scope mount and rings???
« Reply #2 on: August 24, 2011, 01:03:25 PM »
Thank you sir!  ;)
Logged
"ROLL TIDE". . .Back To Back. . .Three In The Last Four Years "GO GIANTS"  "YANKEES"

Offline oneoldsap

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 220
Re: Remington 7600 scope mount and rings???
« Reply #3 on: August 25, 2011, 07:07:57 AM »
                  You can get the 2 piece Talleys for about $50.00 , and save some weight , they work great .
Logged
Pages: [1]   Go Up
« previous next »