« previous next »
Pages: [1]   Go Down

Author Topic: Case length too short  (Read 320 times)

0 Members and 1 Guest are viewing this topic.

Offline thirdbase

  • Trade Count: (0)
  • Member
  • *
  • Posts: 18
Case length too short
« on: August 24, 2011, 11:40:34 AM »
I just bought a bag of 50 Winchester factory cases for a 7mm-08.  About a third of them are shorter than the recommended length of 2.025 by 3 to 4 thousandths.  What do you guys do about cases that are too short?
Logged

Offline Graybeard

  • Administrator
  • Trade Count: (69)
  • Senior Member
  • *****
  • Posts: 26946
  • Gender: Male
Re: Case length too short
« Reply #1 on: August 24, 2011, 12:19:09 PM »
Just load and shoot them. After a firing or two they will be too long and need trimmed and then you can trim them all to same length. That few thousands is no biggie.
Logged


Bill aka the Graybeard
President, Graybeard Outdoor Enterprises
256-435-1125

I am not a lawyer and do not give legal advice.

Jesus is the way, the truth, and the life anyone who believes in Him will have everlasting life!

Offline thirdbase

  • Trade Count: (0)
  • Member
  • *
  • Posts: 18
Re: Case length too short
« Reply #2 on: August 24, 2011, 12:33:29 PM »
I was hoping that was the way to go.  Thanks.
Logged

Offline Jason F

  • Trade Count: (261)
  • Senior Member
  • *****
  • Posts: 2105
  • Gender: Male
Re: Case length too short
« Reply #3 on: August 24, 2011, 03:13:00 PM »
When I form whelen brass from 06 brass they are 20 thousandths short they stretch little by little everytime you shoot them
Logged
handi rifles- 22 mag      22 hornet    223      7mm-08      308 chip shot     30-30 x2     30-06 shorty      358 cheez whiz     357 max     35 remington     375-08    410 rifled slug     454 casull     460 s&w     45 smokeless muzzleloader x2     45-70    50 huntsman    50-70 government shikari     20 ga.ush     12 ga.ush    12 ga.3 1/2     10 ga.imp.cyl. slug gun
Pages: [1]   Go Up
« previous next »