« previous next »
Pages: [1]   Go Down

Author Topic: 140 ftx bullets in 357 max  (Read 512 times)

0 Members and 1 Guest are viewing this topic.

Offline Jason F

  • Trade Count: (261)
  • Senior Member
  • *****
  • Posts: 2105
  • Gender: Male
140 ftx bullets in 357 max
« on: September 09, 2011, 05:45:23 AM »
Anybody ever loaded these, do you trim the brass off or leave it full length, I am loading these for my handi rifle,all the ftx data says trim brass down
Logged
handi rifles- 22 mag      22 hornet    223      7mm-08      308 chip shot     30-30 x2     30-06 shorty      358 cheez whiz     357 max     35 remington     375-08    410 rifled slug     454 casull     460 s&w     45 smokeless muzzleloader x2     45-70    50 huntsman    50-70 government shikari     20 ga.ush     12 ga.ush    12 ga.3 1/2     10 ga.imp.cyl. slug gun

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
Re: 140 ftx bullets in 357 max
« Reply #1 on: September 09, 2011, 07:09:20 AM »

Trimming brass for FTX bullets is only required for leverguns and revolvers as stated in the load note, longer COLs are not normally a problem in a single shot.

Tim

http://www.hornady.com/assets/files/ftx_load_data/357MagFTXRifle.pdf
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »