« previous next »
Pages: [1]   Go Down

Author Topic: Question about brass  (Read 304 times)

0 Members and 1 Guest are viewing this topic.

Offline rescue_171

  • GBO Supporter
  • Trade Count: (78)
  • Contributor
  • *****
  • Posts: 341
  • Gender: Male
Question about brass
« on: October 14, 2011, 08:52:10 PM »
I got some nickle 357 mag brass today that is WRA headstamp but the kicker is that it has large primer pockets.
 
Can anyone tell me about this stuff? Never seen 357 brass with large primer pockets
 
Headstamp just says  W.R.A. S&W 357 Magnum
Logged

Offline tacklebury

  • GBO Supporter
  • Trade Count: (12)
  • Senior Member
  • *****
  • Posts: 3633
  • Gender: Male
  • Central Michigan
Re: Question about brass
« Reply #1 on: October 15, 2011, 12:12:16 PM »
Logged
Tacklebury --}>>>>>    Multi-Barrel: .223 Superlite, 7mm-08 22", .30-40 Krag M158, .357 Maximum 16-1/4 HB, .45 Colt, .45-70 22" irons, 32" .45-70 Peeps, 12 Ga. 3-1/2 w/ Chokes, .410 Smooth slugger, .45 Cal Muzzy, .50 Cal Muzzy, .58 Cal Muzzy

also classics: M903 9-shot Target .22 Revolver, 1926 .410 Single, 1915 38 S&W Break top Revolver and 7-shot H&R Trapper .22 6" bbl.

Offline blpenn66502

  • Trade Count: (17)
  • Avid Poster
  • **
  • Posts: 176
Re: Question about brass
« Reply #2 on: October 16, 2011, 03:37:03 AM »
Read an article in Handloader magazine a while back about S&W Registered 357s.  As a side note, the author indicated that for the first few years after the creation of the 357 mag, mid-1930s, it used a large primer.
Logged
Pages: [1]   Go Up
« previous next »