Author Topic: oops large rifle primers in 45 lc  (Read 1144 times)

0 Members and 1 Guest are viewing this topic.

Offline wileynet

  • Trade Count: (30)
  • Contributor
  • ***
  • Posts: 378
  • Gender: Male
oops large rifle primers in 45 lc
« on: December 09, 2011, 09:57:19 PM »
loaded about 200 rounds of long colt 6.0 grains of titegroup behind 160 lead bullet when counting primer boxes, afterwords found 1 box of  winchester LP primers and 1 box of winchester LR any risk in shooting them, primers seated flush, most brass is RP with some starline new or OF
"The beauty of the second amendment is that it will not be needed until they try to take it." -Thomas Jefferson

Huntsman 58,NEF 45/70 manlicher stock, H&R 308, 30-06, 12 ga, 20 ga, H&R 223, H&R 204 varmiter,H&R 243, H&R 44mag, SMLE No 1 MKIV,SMLE No4 MK1, Savage 110 7mm, Ruger BH 45LC, Security Six, SR9, S&W 22a, CVA MTN Rifle, Optima

Offline LanceR

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 420
Re: oops large rifle primers in 45 lc
« Reply #1 on: December 10, 2011, 12:10:49 AM »
Ouch!  If it were me I tear them down and fire all the primers.  Then I'd start over.  as a guess the large rifle primers would seem to be quite a bit hotter in order to ignite the larger charge.  In any case, why risk getting hurt or killed?

Lance

Offline MePlat

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 601
Re: oops large rifle primers in 45 lc
« Reply #2 on: December 10, 2011, 01:48:49 AM »
I would not be afraid to shoot them at all.  That is a piddling load and pressures wouldn't be enough to be concerned about.  even in a colt or a colt clone.
Hodgdons lists 7.0 grains with a 160 gr bullet at 9100 CUP's  Sammi specs lists 15500 CUP's as average max for standard loads for a 45 Colt.
Being careful is great but one has to be resonable.
You Know Me.  I Don't Have a Clue

Offline Grumulkin

  • Trade Count: (33)
  • Senior Member
  • *****
  • Posts: 2028
    • http://www.orchardphoto.com
Re: oops large rifle primers in 45 lc
« Reply #3 on: December 10, 2011, 03:33:05 AM »
As long as the load was conservative to begin with, I wouldn't have a concern about shooting them.  The primer does little other than to light the fire.  It's kind of like if you have a big pile of brush to burn and ask if you'll have a bigger fire if you light it with a match as opposed to lighting it with a road flare.

Offline Rock Home Isle

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 902
  • This is Rock Home Isle
Re: oops large rifle primers in 45 lc
« Reply #4 on: December 10, 2011, 03:52:35 AM »
Made that very mistake before...I shot the first 6 rounds with my revolver roped to a post and I pulled a string that was tied to the trigger. The load was a mild Cowboy Action Load, so I wasn't toooo worried...but still I didn't want to be holding the gun should something go way wrong.  :o 
 
The rounds fired off just fine, so I finished off the rest of the loads as normal and had no problems...Now I store all my rifle and pistol primers in separate containers, and I use a separate press for pistol reloading.
“Lost?? Hmmm... been fearsome confused for a month or two, but I ain't never been lost!”
Henry Frap the "Mountain Men"

“Ain't this somethin'? I told my pap and mam I was going to be a mountain man; acted like they was gut-shot. Mother Gue said to me; ‘Make your life go here, son. Here's where the people is. Them mountains is for Indians and wild men.’  "Mother Gue", I says "the Rocky Mountains is the marrow of the world," and by God, I was right. Keep your nose in the wind and your eye along the skyline.”
Del Gue in "Jeremiah Johnson"

Offline mdi

  • GBO Supporter
  • Trade Count: (1)
  • Contributor
  • *****
  • Posts: 399
  • Gender: Male
Re: oops large rifle primers in 45 lc
« Reply #5 on: December 10, 2011, 08:28:48 AM »
I'd shoot 'em
 
Years ago, pre web, I reloaded some .44 Specials with Large Rifle primers. I made sure they were seated flush and I couldn't tell any difference when shot. I tried LR primers on purpose, just 'cause I wanted to see what would happen with accuracy (I was using Unique).
 
FWIW; When I reload I place all the components I will be using on my bench, brass, primers, powder, bullets (only those components I'm gonna use for a particular load). I also write the load data on a sticky note and stick it on my powder measure. This way I can double check all components as I use them (size and amounts). When batch loading I'll sometimes just size/prime a bunch of brass and only get out the primers I'll be using, and leave them on the bench in full view. With my anal precautions I haven't had an OOPS! in nearly 25 years...

Offline Rock Home Isle

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 902
  • This is Rock Home Isle
Re: oops large rifle primers in 45 lc
« Reply #6 on: December 10, 2011, 12:46:27 PM »
Nice quality control methods there mdi...  8)
“Lost?? Hmmm... been fearsome confused for a month or two, but I ain't never been lost!”
Henry Frap the "Mountain Men"

“Ain't this somethin'? I told my pap and mam I was going to be a mountain man; acted like they was gut-shot. Mother Gue said to me; ‘Make your life go here, son. Here's where the people is. Them mountains is for Indians and wild men.’  "Mother Gue", I says "the Rocky Mountains is the marrow of the world," and by God, I was right. Keep your nose in the wind and your eye along the skyline.”
Del Gue in "Jeremiah Johnson"

Offline sr sawyer

  • GBO Supporter
  • Trade Count: (70)
  • A Real Regular
  • *****
  • Posts: 599
  • Gender: Male
Re: oops large rifle primers in 45 lc
« Reply #7 on: December 10, 2011, 04:48:38 PM »
OOPS and CRS have a lot in common.  Follow mdi's advice and you will continue to enjoy the world of reloading. 
 
Ken
NRA Life Member

Offline Ranch13

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 1062
  • Gender: Male
    • Historic Shooting .com
Re: oops large rifle primers in 45 lc
« Reply #8 on: December 10, 2011, 05:31:15 PM »
I load large rifle primers in the 45 colt quite often , most especialy for +p type loads in my Winchester trapper, and it's heavy hammer fall . My old Blackhawk handles those primers quite well also.
As long as the primer pockets are deep enough there should be no problem.
 
In the 1920's "sheeple" was a term coined by the National Socialist Party in Germany to describe people that would not vote for Hitler. In the 1930's they held Hitler as the only one that would bring pride back to Germany and bring the budget and economy back.....

Offline gypsyman

  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 4852
Re: oops large rifle primers in 45 lc
« Reply #9 on: December 14, 2011, 03:26:28 AM »
Sierra manual just says to back off your load when using a hotter primer. I would be more concerned with the hardness of the primer, and a pistol not having as much ''hit'', as a rifle firing pin. But, it looks like it worked out. gypsyman
We keep trying peace, it usually doesn't work!!Remember(12/7/41)(9/11/01) gypsyman

Offline Blackhawker

  • Trade Count: (38)
  • Senior Member
  • *****
  • Posts: 1486
Re: oops large rifle primers in 45 lc
« Reply #10 on: December 14, 2011, 03:47:22 AM »
The loads will probably be OK but just to let you in on something, you might think about this:

Just two weeks ago, I witnessed a gun blow up from a shooter sitting 15 ft away from me that was using Titegroup.  The shooter mistakenly loaded incorrectly, just as you have done.  His mistake wasn't with primers but a charge error.  Mistakes can only be taken back BEFORE you pull the trigger and it's hard to say "I'm sorry" when someone has lost an eye or is dead.  Call me a little "gun shy" but after having a washer stuck in the side of my head and that things could have been worse, I'd break the loads down and load them correctly.  Either that or you make sure you go shoot those rounds off alone and away from other people.   >:(

Believe me, for a moment I had fleeting thoughts of showing that shooter the business end of the revolver I had in my hand.  If it wasn't a friend, I'm sure the thoughts wouldn't have been so fleeting.

Offline wncchester

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 3856
  • Gender: Male
Re: oops large rifle primers in 45 lc
« Reply #11 on: December 15, 2011, 11:28:10 AM »
Shoot 'em, you will have no pressure problem and IF the primers are seated at least flush there will be no cylinder rotation problem.  Large frame single action revolvers usually have more than sufficent hammer impact to set rifle caps off.
Common sense is an uncommon virtue

Offline mechanic

  • GBO Supporter
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 5112
  • Gender: Male
Re: oops large rifle primers in 45 lc
« Reply #12 on: December 15, 2011, 11:33:59 AM »
I've been working up all my pistol loads with lr primers, because I have a lot of them, and because I use the same loads in rifles as well.  I don't shoot 45lc, but I do load 44 mag. and 357 mag.  I personally would shoot them.
 
Ben
Molon Labe, (King Leonidas of the Spartan Army)

Offline Rock Home Isle

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 902
  • This is Rock Home Isle
Re: oops large rifle primers in 45 lc
« Reply #13 on: December 22, 2011, 05:25:52 AM »
Snow today and we're off for Christmas break...
 
I'm going to reload about 200 rounds of .45 Colt today. Sit by the window and enjoy the snow falling outside...nice way to spend the day.  8)
“Lost?? Hmmm... been fearsome confused for a month or two, but I ain't never been lost!”
Henry Frap the "Mountain Men"

“Ain't this somethin'? I told my pap and mam I was going to be a mountain man; acted like they was gut-shot. Mother Gue said to me; ‘Make your life go here, son. Here's where the people is. Them mountains is for Indians and wild men.’  "Mother Gue", I says "the Rocky Mountains is the marrow of the world," and by God, I was right. Keep your nose in the wind and your eye along the skyline.”
Del Gue in "Jeremiah Johnson"

Offline bilmac

  • GBO Supporter
  • Trade Count: (14)
  • Senior Member
  • *****
  • Posts: 3560
  • Gender: Male
Re: oops large rifle primers in 45 lc
« Reply #14 on: December 22, 2011, 06:18:28 AM »
I've seen some writers recommend LR primers for cartridges they shoot in both rifle and pistol because they shoot a little straighter in the rifle.