« previous next »
Pages: 1 [2]   Go Down

Author Topic: 3.5" SAA that isn't made yet  (Read 3802 times)

0 Members and 1 Guest are viewing this topic.

Offline painted horse

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 226
Re: 3.5" SAA that isn't made yet
« Reply #30 on: February 18, 2012, 04:58:19 AM »
My wife has a couple Cimmeron Thunderers with the 1st Gen. frame. Those set screws for the base pin are a pain in the butt....if you get them tight enough (finger tight ain't enough)that they don't shoot loose and fall out (try and find one of those little beautys after it hits the ground) you better have a pair of pliers in your pocket if you have to pull the cyl for any reason. Maybe I'll have them slotted to accept a coin and try that.  I hate em'....  >:(
Logged

Offline gcrank1

  • Trade Count: (24)
  • Senior Member
  • *****
  • Posts: 7644
  • Gender: Male
Re: 3.5" SAA that isn't made yet
« Reply #31 on: February 23, 2012, 11:11:01 AM »
Im with you, there is a good reason Colt's went to the 'improved' take-down........
Logged
"Halt while I adjust my accoutrements!"
      ><   ->
We are only temporary caretakers of the past heading toward an uncertain future
22Mag UV / 22LR  Sportster
357Mag Schuetzen Special
45-70  SS Ultra Hunter with UV cin.lam. wood
12ga. 'Ol' Ugly OverKill', Buck barrel c/w  SpeedStock  and swap 28" x Full bird barrel, 1974
Pages: 1 [2]   Go Up
« previous next »