« previous next »
Pages: [1]   Go Down

Author Topic: Need the screw size/type  (Read 328 times)

0 Members and 1 Guest are viewing this topic.

Offline wganz

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 414
Need the screw size/type
« on: February 23, 2013, 02:07:54 PM »
I recently ordered two H&R hammer extension. When I went to mount it on the hammer, I noticed it didn't have a set screw. Guess they were separate in the package and are now lost. :-[ Does anyone have the screw size and type I'd need to get from the local screw/bolt/nut/fastner shop?


BTW. Since I'm going there. Could someone kindly post the thumb screw size so I can get a couple while I'm there.


Do appreciate it all.
Logged

Offline trotterlg

  • GBO Supporter
  • Trade Count: (36)
  • Senior Member
  • *****
  • Posts: 3978
  • Gender: Male
Re: Need the screw size/type
« Reply #1 on: February 23, 2013, 07:16:05 PM »
Just pulled one out and looked at it, can't measure it, but my bet is that it is a 4-40, should not cost you more than about $1.00 to see if I am right.  Larry
Logged
A gun is just like a parachute, if you ever really need one, nothing else will do.

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43300
  • Gender: Male
Re: Need the screw size/type
« Reply #2 on: February 23, 2013, 07:56:34 PM »
From the FAQs...

Quote
The hammer extension set screw is an 8-32 socket head that takes a 5/64" or 1/16" allen wrench, depends on when the extension was made.
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain
Pages: [1]   Go Up
« previous next »