Author Topic: mark on brass (Read 341 times)

josebd · « **on:** February 20, 2004, 08:42:22 AM »

i was getting a mark all the way around on my .223 brass using my rcbs full length die,sent it in and they replaced it. in the mean time i was using lee die and i started getting the same marks? i was cleaning the die after every 20 or 30 shells. the mark is below the shoulder halfway between the shoulder and base. whats causing this?

jgalar · « **Reply #1 on:** February 20, 2004, 08:52:48 AM »

cut one of the cases in half and check to see if the brass is thinner at the mark. If it is reduce your loads.

josebd · « **Reply #2 on:** February 21, 2004, 09:12:21 AM »

i resized some new brass and it left the mark?

Red Neck64 · « **Reply #3 on:** February 23, 2004, 02:17:27 PM »

It's normal to get marks on brass.