« previous next »
Pages: [1]   Go Down

Author Topic: 32/40 loads and loading?  (Read 694 times)

0 Members and 1 Guest are viewing this topic.

Offline hans g./UpS

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 273
32/40 loads and loading?
« on: March 16, 2004, 02:21:07 AM »
A friend has a drilling in 32/40.
Any sources of dies and brass?,loads?,can the brass be made from other calibers?
Thanks.
Logged

Offline ricciardelli

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1004
  • Gender: Male
    • http://stevespages.com/page8.htm
32/40 loads and loading?
« Reply #1 on: March 16, 2004, 02:44:24 AM »
Loading data:
http://stevespages.com/321_2_170.html

Case dimensions:
http://stevespages.com/jpg/cd3240.jpg

Brass is currently made by Winchester
Logged

Offline gewehrfreund

  • Trade Count: (1)
  • Avid Poster
  • **
  • Posts: 139
32/40 loads and loading?
« Reply #2 on: March 16, 2004, 02:46:08 AM »
Just about all the die makers offer 32-40 WCF dies. Winchester has recently made a run of 32-40 brass, but most of mine has been made from 38-55 brass. Just use Imperial Sizing Wax or something similar and run the 38-55 through the 32-40 sizing die.
You can find load data in some of the current powder manufacturer manuels (i.e. Accurate Arms), or in older books, but the best source is probably the various web based reloading sites.

P.S. If light loads are used, it should be possible to load 32-40 by neck sizing only with a 32 Win. Special die set.
Logged
Pages: [1]   Go Up
« previous next »