« previous next »
Pages: [1]   Go Down

Author Topic: How to untite LOK-TITE  (Read 2690 times)

0 Members and 1 Guest are viewing this topic.

Offline Jagdzeit

  • Trade Count: (0)
  • Member
  • *
  • Posts: 96
How to untite LOK-TITE
« on: October 06, 2003, 02:40:51 AM »
I know that indians didn't have this stuff in their bag of tricks. But we do and at times it makes taking things apart a real Pain In The A.

So, if you come across a screw that has been loc-tited and are having a hard time removing it. Heat will break down the loc-tite. Only about 200 degrees is needed to break it down. Either a heat gun or a pot of boiling water for a few minutes will do the job.

Stay Safe,
Franz
Logged
Oppose the 2nd Amendment, you're an enemy of the Bill of Rights.
Enemy of the Bill of Rights, you 're an enemy of the Constitution.
Enemy of the Constitution, you're an enemy of The People.
Enemy of The People, you're an enemy of mine.  :blaster:

Offline Tom W.

  • Moderators
  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1294
  • Gender: Male
  • Warning... Does not play well with others!
How to untite LOK-TITE
« Reply #1 on: October 18, 2003, 05:38:42 PM »
A sharp rap on a good fitting screwdriver will also work.
Logged
Tom
Alabama Hunter and firearms safety instructor

I really like my handguns!

Offline Swamp Fox

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 227
How to untite LOK-TITE
« Reply #2 on: October 19, 2003, 04:21:43 PM »
You should always use a removable loctite for gunsmithing. (I know this from personal error.)

I have found that an old screw driver/hex wrench/torx driver can be used to heat the offending screw. Put the driver in the screw and heat the shaft of the driver with a tourch. Then use a good driver to remove the screw.

I think this is the method old indians use on thier take down bows. :)
Logged
"We may not imagine how our lives could be more frustrating and complex—but Congress can." —Cullen Hightower

Offline bigbore

  • Trade Count: (0)
  • Member
  • *
  • Posts: 22
How to untite LOK-TITE
« Reply #3 on: December 01, 2003, 06:28:25 PM »
You can also freeze the part, to loosen it, below 32 degrees.
Logged
NRA Benefactor Member

Offline Camp Cook

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 683
How to untite LOK-TITE
« Reply #4 on: June 10, 2004, 09:46:11 AM »
I have used WD-40 to break down the Loc-Tite. Spray some on and let it soak for a while. Then just turn out that screw.
Cam
Logged
<")))><

"A gun is a tool, Marian. No better, no worse than any other tool. An axe, a shovel, or anything. A gun is as good or as bad as the man using it. Remember that" -movie "Shane" 1953
Pages: [1]   Go Up
« previous next »