« previous next »
Pages: [1]   Go Down

Author Topic: New mold-fewer grooves.  (Read 376 times)

0 Members and 3 Guests are viewing this topic.

Offline Dusty Miller

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 2271
  • Gender: Male
New mold-fewer grooves.
« on: September 30, 2004, 04:53:29 PM »
My 336gr. mold for my .44 mag has three grooves.  I put lube into two of them and crimp into the third.  The new mold (240 gr.) has only TWO grooves.  Do I put lube into one and crimp into the other or lube both and crimp higher up the bullet sans benefit of a groove?
Logged
When seconds mean life or death, the police are only minutes away!

Offline Lloyd Smale

  • Moderators
  • Trade Count: (32)
  • Senior Member
  • *****
  • Posts: 18171
New mold-fewer grooves.
« Reply #1 on: September 30, 2004, 10:59:45 PM »
lube one crimp one the top grove should look a little differnt then the bottom grove. It shoud taper a little toward the bottom of the bullet to allow for crimping. One lube grove is all you need if you use a good lube.
Logged
blue lives matter
Pages: [1]   Go Up
« previous next »