« previous next »
Pages: [1]   Go Down

Author Topic: williams WGRS peep sight question  (Read 778 times)

0 Members and 1 Guest are viewing this topic.

Offline nebrguy

  • Trade Count: (0)
  • Member
  • *
  • Posts: 60
williams WGRS peep sight question
« on: November 24, 2004, 06:36:12 AM »
when using the williams WGRS peep sight on handi rifles, can a shooter still use the factory front sight, or must it be replaced too?..also, when using this peep sight,  does the factory rear sight have to be removed so not to be in the visual way?  any thoughts on these sights would be appreciated. thanks
Logged

Offline MSP Ret

  • GBO Supporter
  • Trade Count: (173)
  • Senior Member
  • *****
  • Posts: 8940
  • Gender: Male
williams WGRS peep sight question
« Reply #1 on: November 24, 2004, 06:45:21 AM »
I put an open blade Williams Guide sight on a Handi barrel I had and replaced the front sight with an H&R front sight for a .22 Hornet. I had been informed at that time (about a year ago) that that particular front sight blade was the highest front sight made by H&R and it worked fine. I would think a front sight from any of the superlight barrels should he high also. Now since they have introduced a couple of superlight barrels perhaps they have a higher front sight. It would not hurt if the front sight blade was even a bit higher than the .22 Hornet front blade....<><.... :grin:

by the way, the base of the WGS is the same for the peep sight and the open blade, you can even switch the inserts from blade to peep and they are available seperately in their catalog, so I think the application would be the same for an open blade and a peep,,,,
Logged
"Giving up your gun to someone else on demand is called surrender. It means that you have given up your ability to protect yourself to a power that is greater than you." - David Yeagley

Offline Badnews Bob

  • Trade Count: (34)
  • Senior Member
  • *****
  • Posts: 2963
  • Gender: Male
williams WGRS peep sight question
« Reply #2 on: November 24, 2004, 08:07:02 AM »
I use the WGRS on my .357mag and a Williams FP (From NEF) on my .357max I had to use the hornet front blade with both to get correct elevation, They work great, I don't know about leaving the rear sight on I didn't try I just took them off. They may work with the factory front blade but I don't think you would be able to sight in past 75yards give or take a few. 8)
Logged
Badnews Bob
AE-2 USN retired

Offline ping925

  • Trade Count: (0)
  • Member
  • *
  • Posts: 33
williams WGRS peep sight question
« Reply #3 on: November 24, 2004, 10:29:28 AM »
I called customer service--they said the one in the catalog only fits the target and buffalo classic-the front site is not high enough.  The Williams catalog lists a "new" one for Handis.  I am waiting until after deer season to pursue further.
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
williams WGRS peep sight question
« Reply #4 on: November 24, 2004, 10:33:48 AM »
Welcome to GBO!  :D Hope ta see ya around more often... :wink:
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline nebrguy

  • Trade Count: (0)
  • Member
  • *
  • Posts: 60
williams WGRS peep sight question
« Reply #5 on: November 24, 2004, 11:45:32 AM »
i apologize for not stating that my rifle & questions are geared for the 45-70 barrel. among you 45-70 handi rifle owners that went with the williams wgrs peep sight, could you have used the original front sight and been able to zero properly?  can the factory rear be left on without  problems?..thanks again
Logged

Offline .308

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 489
front sights
« Reply #6 on: November 27, 2004, 02:04:12 PM »
Does anyone know if there are taller replacement front sights available from manufactures other than H&R that will work with the WGRS? Or has someone come up with a do-it-yourself design that works well? :D
Logged

Offline quickdtoo

  • Global Moderator
  • Trade Count: (149)
  • Senior Member
  • *****
  • Posts: 43301
  • Gender: Male
williams WGRS peep sight question
« Reply #7 on: November 27, 2004, 02:12:00 PM »
Logged
"Always do right, this will gratify some and astonish the rest" -  Mark Twain

Offline .308

  • Trade Count: (0)
  • Contributor
  • ***
  • Posts: 489
Thanks...
« Reply #8 on: November 27, 2004, 05:29:16 PM »
Thanks quickdtoo. :wink:
Logged
Pages: [1]   Go Up
« previous next »