« previous next »
Pages: [1]   Go Down

Author Topic: tap size scope mount handi  (Read 478 times)

0 Members and 1 Guest are viewing this topic.

Offline 3006bluffhunter

  • Trade Count: (28)
  • Contributor
  • ***
  • Posts: 274
tap size scope mount handi
« on: December 04, 2004, 10:31:30 AM »
:D Hello was wondering what is the thread size of the receiver on a handi where the scope mount screws go.....I need to buy a tap and was wondering what tap size i need.....they just need a good cleaning out with a tap.....I need a tap number like 0-00...and a factory screw #so I can get new screws...Thanks to all that reply   Dale P.S. tap number is a must
Logged

Offline Fred M

  • GBO Supporter
  • Trade Count: (1)
  • Senior Member
  • *****
  • Posts: 2362
    • Fred The Reloader and Wildcatter
tap size scope mount handi
« Reply #1 on: December 04, 2004, 10:56:21 AM »
Weaver type bases use a 6-48 screws and threads. But if you drill and tap new holes I would go for the 8-40 screws. Both these sizes are not readily availabe in tool shops. You will have to get them from Brownell both drills screws and taps.
Logged
Fred M.
From Alberta Canada.
Pages: [1]   Go Up
« previous next »