« previous next »
Pages: [1]   Go Down

Author Topic: Question  (Read 277 times)

0 Members and 3 Guests are viewing this topic.

Offline MIdeerhunter

  • Trade Count: (0)
  • Avid Poster
  • **
  • Posts: 108
Question
« on: February 03, 2005, 12:50:47 PM »
Okay i have heard people saying that they sanded a little bit on the fore-end...well where exactly are you sanding it? I can't figure that out...also how do you know if you are getting uneven pressure from the forearm? And if it is uneven do you just sand there? But i just don't understand how to tell where you are getting uneven pressure... sorry if this is a noob question but i was just tryint to clarify this up...thank-you!
Logged
New England Fireams Tracker II plus (USHD) 12 ga
.223 handi rifle
1903A3 Springfield in 6mm rem.
rem. 870 supermag
ruger 10/22
win. x-150
winchester model 88
savage 24

Offline jeff223

  • Trade Count: (0)
  • Senior Member
  • *****
  • Posts: 1284
Question
« Reply #1 on: February 03, 2005, 02:48:26 PM »
take and sand from the barrel stud hole forward.put the forarm back on and then take two dollar bills and run it between the barrel and the forarm.you dont want the dollar bill to catch anyplace.it will just run between there real easy.i took even more off my forarms than that.

where you from in Michigan?
Logged
Pages: [1]   Go Up
« previous next »