Author Topic: Technique - Installing Mag. Extension  (Read 367 times)

0 Members and 1 Guest are viewing this topic.

Offline John134

  • Trade Count: (0)
  • Member
  • *
  • Posts: 12
Technique - Installing Mag. Extension
« on: September 22, 2004, 10:22:57 AM »
Trying to install two new factory mag extensions on two new factory magazines. How do I accomplish this without bending metal the wrong way or messing them up?

Thanks for any assistance,

John
If you want a guarantee, buy a toaster.     Clint Eastwood

Offline greenjeans

  • Trade Count: (0)
  • A Real Regular
  • ****
  • Posts: 583
Technique - Installing Mag. Extension
« Reply #1 on: September 22, 2004, 01:14:33 PM »
Mags for what pistol? Makes a difference on how to get the bottom off.
Romans 8:38,39

Offline John134

  • Trade Count: (0)
  • Member
  • *
  • Posts: 12
Technique - Installing Mag. Extension
« Reply #2 on: September 22, 2004, 01:47:15 PM »
Project Completed!   Taurus PT-111 (Millennium 9mm).

Pressed through the hole in the bottom plate with a metal end of a pen, this moved the metal part that contacts the spring, then started sliding the end piece off and used a ball point (of the pen) to release tension again and slid the rest of the way. Total time less than a minute on each of the two mags.

Paid under six dollars for factory extensions, and the factory mags were about 22.00 each. Most of the PT111 mags on the web are sold without extensions for more than $30.00. Shop around if you have time, and note: some aftermarket stuff is in a word - junk!

Taurus PT-111 (Millennium 9mm).
If you want a guarantee, buy a toaster.     Clint Eastwood