Author Topic: 45acp,thick,heavy brass? (Read 438 times)

spispeza · « **on:** March 29, 2005, 04:15:41 PM »

I have some amerc brand cases that are too thick,heavy,have had trouble loading with cast,jacketed bullets.also some military brass.the trouble is that some would chamber fine,some will not chamber.i have trimmed,full length sized,chamfered,belled.but still have trouble with them.hate to throw them away.any tips,tricks loading this typeof brass?thanks

Racepres · « **Reply #1 on:** March 29, 2005, 05:05:48 PM »

You may be in a situation like I have encountered w/ a particular 357 revolver that I have. It will not chamber a particular bullet when loaded in a particular brand of brass!!! Why?? excess diameter, yet all components measure within spec. In fact substituting either component (brass / bullet) results in chamberable rounds ... Just luck I guess. Marty

rbwillnj · « **Reply #2 on:** March 29, 2005, 06:13:39 PM »

Throw Amerc Brass Away......Period!

Reed1911 · « **Reply #3 on:** March 30, 2005, 02:01:24 AM »

I second that on throwing away A-Merc brass. It has the be the worst quality control I've seen in ammunition. The brass has mostly off center flash holes, thick brass buildup on one side or the other, etc...
I've heard complaint after complaint of the ammunition itself, what little I have shot of it seems to hold up to the complaints. It's crap ammo and if you need plinking cost ammunition buy something like Wolf or Silver Bear.

Questor · « **Reply #4 on:** March 30, 2005, 03:02:14 AM »

Amerc is the worst brass I've ever encountered. I throw them away on sight. I recommend you do the same. That stuff is awful!!!!!

glock29 · « **Reply #5 on:** April 08, 2005, 06:36:13 AM »

Winchester Win-Clean brass in 45ACP is absolutely awful to size.
Takes AT LEAST 3 to 4 times the force to size than all other brass I have used.
I consider this stuff about as worthy of reloading as Blazer Aluminum or Wolf Steel cases.
Absolute RUBBISH !