« previous next »
Pages: [1]   Go Down

Author Topic: Contender ring height?  (Read 594 times)

0 Members and 2 Guests are viewing this topic.

Offline burntmypiston

  • Trade Count: (0)
  • Member
  • *
  • Posts: 10
Contender ring height?
« on: July 09, 2005, 12:53:32 PM »
Getting a Burris 3x12 for my 223 Contender. Plan on using Burris Signature Zee Weaver style rings. Which height should I go with? I'm thinking "high" but not sure. Thanks.
Logged

Offline Redhawk1

  • Life time NRA Supporter.
  • GBO Supporter
  • Trade Count: (78)
  • Senior Member
  • *****
  • Posts: 10748
  • Gender: Male
Contender ring height?
« Reply #1 on: July 09, 2005, 01:09:46 PM »
I would say Med or High, just to insure you can cock the hammer without an extension.  :D
Logged
If  you're going to make a hole, make it a big one.
ΜΟΛΩΝ ΛΑΒΕ
Only two defining forces have ever offered to die for you,
Jesus Christ and the American G. I.
One died for your soul, the other for your freedom

Endowment Life Member of the NRA
Life Member NA

Offline Darrell H

  • Trade Count: (10)
  • Avid Poster
  • **
  • Posts: 240
Contender ring height?
« Reply #2 on: July 09, 2005, 01:49:22 PM »
I always use "low" scope mounts on rifles so i can keep my face on the stock and look through the scope.  This is not an issue with handguns!  For this reason, I always use high mounts on all my pistol barrels for easier hammer access.  

X
Logged
Pages: [1]   Go Up
« previous next »