Author Topic: Savage 99 Barrel shank (Read 837 times)

BigKnife Slim · « **on:** August 12, 2005, 06:01:51 PM »

Can anyone give me the barrel shank specs for a late model Sav99 detatchable mag V threads thanks

260 AAR · « **Reply #1 on:** August 15, 2005, 07:00:37 AM »

Dear BigKnife,
Last one I did was this:
Shank length---- .1055
Major Dia.------- .896
Minor Dia.--------.825
Thread-- --------12 Square TPI

This was on an older Savage and "may" not be the same as the one you`re working on so I hope this helps. The barrels are horribly tight so be careful removing the old one as I think you can crush/warp the receiver if you`re not careful.

Aloha, Mark

gunnut69 · « **Reply #2 on:** August 16, 2005, 05:44:50 AM »

I think the shank length was meant to be 1.055 inches.

BigKnife Slim · « **Reply #3 on:** August 18, 2005, 04:57:22 PM »

Thanks fellers My action is a clip model it has V threads 14 to the inch I dont have a barrel for proto type. My measure, I come up with.947 from action face to collar, .899 from action face to bolt face, .836 to the tops of the action threads and this is the one I could use some help with about .906 to the bottoms. I got this last # form the small counterbore in front of the threads. But the counterbore may be deeper than the bottom of the thread. Thanks again.