Author Topic: Filler? (Read 313 times)

Cuz · « **on:** July 28, 2005, 07:35:12 AM »

What, if any, do you use as a filler. Intent is to load for 44mag. IF, you do not use filler, why?

Cuz

Ragn-Cajn · « **Reply #1 on:** July 28, 2005, 12:05:32 PM »

I have loaded 1000's of 44 mag and nver used a filler.
Why not? it is not needed

sharps4590 · « **Reply #2 on:** July 30, 2005, 12:07:06 PM »

I'm kinda like Ragin'-cajn. I've loaded thousands of 44 Mag in the past, altho I no longer own one, and I never needed a filler. The only circumstance I can think of that you might need one in a 44 is if you're using a very light charge of a very fast burning powder, which is neither good nor necessary.

Vic

JBMauser · « **Reply #3 on:** July 31, 2005, 03:46:19 AM »

I use kapok as a filler in rifle cartridges where the powder charge is low in volume compared to the cartridge case. I do not use it in pistol at all. The lowest volume to case capacity powders I use in pistol are Bullseye and Clays which are similar in that they are consistant even in large cases. The only area where I know fillers are used in pistol is with Black powder in large cases where you want to reduce the charge and not allow a dangerous air space in the charge which BP requires. Fillers in pistol cartridges may be dangerous. I know that .40S&W loaded with 10mm bullets leaves too little or no air space and causes pressures to go off the chart and it is not recomended. When you ask about fillers in general you need to frame the question with a powder charge and powder type as well as the cartridge and bullet. That stool has four legs. JB

Questor · « **Reply #4 on:** July 31, 2005, 03:57:51 AM »

Even for light loads, filler isn't needed if you're using a mainstream powder like Winchester 231 (a good powder for light 44 magnum loads.)